The most common variety of DC power sockets (barrel jack/barrel socket), 5.5mm hole with 2.1mm center (5.5x2.1)
This variant is "slimmer" than the normal ones, needing only an 8mm hole or so and the bezel is only 10mm or so. Also has an attached rubber boot/cap which can plug into the hole to keep stuff out. I'm not sure how water proof it would be, but should be at least somewhat "splash" resistant.
Attention! if you are using a solderable-plug, I wouldn’t use these sockets, for some reason the solderable plugs are a too-tight fit in these, they are fine with moulded plugs. If using a solderable plug, I recommend any of the other 5.5/2.1 sockets I sell, they all fit just fine.
Nut included. Solder tabs on the back to connect your wires.
I also have a few other styles of 5.5/2.1 socket and plugs, check my listings of these here:
That’s about all that can be said!
All of our products are shipped from Christchurch, New Zealand using CourierPost for NZ, and Airmail for international.
