This listing is for a prewired set of PH type (aka PH-2.0, JST-PH) through hole wire-to-board connectors
Each "item" you buy gets you a pack containing:
1 of PCB mount pin header (vertical through hole)
1 of plug with wires already attached
You can choose from the following packs…
PLEASE NOTE! Check your polarities, don't just assume "oh, red, that must be X volts, oh black that must be ground", I don't know what voltages or signals your device puts or expects on each wire and neither does the Chinese factory that made these wires. Check twice, don't burn your house down.
PH connectors have a 2.0mm pin pitch and can carry about 2A Maximum. They are commonly used for power from batteries (2p) and balancing connectors (3p+) of course you can also use them for data, or servos or motors or potentiometers or anything.... that's kinda how connectors work, they connect things, who knew.
It's a lot easier than crimping your own PH connectors that's for sure. But if you did want to crimp your own, check out my other listings for just the connectors and pins!
Check my other listings for different PH socket types available
All of our products are shipped from Christchurch, New Zealand using CourierPost for NZ, and Airmail for international.
